Defog Mask Infographic

Applying Defog Correctly to your Scuba Mask

Commercial defogging solutions are not only more effective than saliva, they also inhibit the growth of bacteria in your mask between dives. Nevertheless, how can you use them most effectively?

Here is the short version: Read the directions. Although the basic directions for applying most defog is the same, do not simply assume this is true for the defogging solution you are using. Read the directions and follow them precisely.
Scuba Mask Defog
Here are some general recommendations that apply to most mask defogging solutions:

  • Start with a clean lens: Do not let a layer of dirt and grime get between your mask lens and the defogging solution. If need be, clean the mask before applying defog. Remember, new masks require special preparation steps in order for de-fog to work effectively. See New Mask Preparation.
  • Don’t wet the mask lens first. If you do, you may prevent the defog from adhering to the glass and increase the odds it will wash off prematurely. Defog generally works best when applied to a dry lens.
  • Don’t rinse too aggressively. Odds are the manufacturer’s instructions will say to rinse the mask slightly — just enough to remove any excess defog that may have built up in a particular area. More than this and you will just rinse your defog right off again.

Follow these steps and you can help make every dive fog-free.

Everything you need to know about your scuba maskFor more tips on your scuba mask
Check out our post – Everything you need to know about your scuba mask »

Related Blog Articles

0 回復




發佈留言必須填寫的電子郵件地址不會公開。 必填欄位標示為 *